The 3061 power amplifier provides 500 W PEP output power suitable for voice and data operation.

Codan’s power amplifiers are reliable, affordable and designed for use with our transceivers. Codan’s Sentry-H 6120-BM and Envoy transceivers provide users with a simple interface to control and operate the 3061 power amplifier. Fault conditions are automatically detected and reported to the user via the transceiver interface. The 3061 power amplifier automatically switches to stand-by mode when it is not being used, or when the attached transceiver is powered off.

Codan Hf Amplifier3061 500W Ptb

Key Features

Continuous mode operation

Rated for 100% continuous operation in all HF modes for either voice or data communications.

High efficiency

Advanced switch mode power supplies are used to maximise efficiency and reduce heat.

Protection and backup

Fully protected against all load conditions and excessive heat sink temperatures. Capable of operating with loads of VSWR of up to 3:1 with reduced output power.

Antenna tuner interface

Provides an interface to control an external antenna tuner or coupler. The connected transceiver automatically performs a tune whenever a new transmit frequency is chosen.

Front panel LED indicators

The front panel LED indicators provide a visual indication of the fault conditions including internal fault, VSWR and over temperature. An LED bar graph is provided to display either the PEP output power or supply current status.

Amplifier cooling

Extensive heatsinks with fan forced airflow cooling allow for increased reliability and durability. The fans are thermostatically controlled and operate on two speeds depending on the heatsink temperature.

Rack mounting

The 3061 power amplifier and its associated power supply units are designed for use in 19” rack mount configurations and are 5RU high. Front air exhausts allows easily installation in virtually any type of 19” rack.

Specifications

  • General
  • RF power output 500W PEP ±1 dB, 300W average
  • Frequency range 1.6 to 30 MHz
  • Input/output impedance 50 Ω
  • Operating temperature –10 to +60°C
  • Duty cycle 100%: normal speech over full temperature range
    100%: all modes up to maximum ambient of 45°C
  • Power supply 100–240 V AC ±10%, 50/60 Hz single phase
  • Power consumption 800 VA (two-tone), 900 VA maximum
  • Protection Safe under all load conditions
    Bypass to 125W PEP from transceiver in the event of excess
    VSWR, excess heatsink temperature or internal fault conditions
  • Spurious and harmonic emissions Better than 60 dB below PEP
  • Intermodulation distortion Better than 32 dB below PEP
  • Cooling Fan forced front panel exhaust
    Thermostatically controlled dual speed
  • Size Amplifier (5RU 19″ rack): 22.2 x 48.3 x 41.0 cm (H x W x D)
    Power supply (5RU 19″ rack): 22.2 x 48.3 x 41.0 cm (H x W x D)
  • Weight 15.4 kg, Power supply: 6.7 kg

Values noted are typical. Equipment descriptions and specifications subject to change without notice or obligation.

Challenging requirements?
Speak to an expert today to design your solution.