- Description
-
UIC-4-00 Firmware
Requirements:- Firmware Flashing Software Version 1.9.2.0 or later. if not previously installed.
- Universal Interface Card Configuration Utility Version 2.3.0.0 or later.
Notes:
- This update can only be applied to firmware versions 2.0 and later.
- The UIC-4-00 has now been discontinued and replaced by the new UIC-5-00 IP Interface control card. Please contact LMRSupport@codancomms.com with any questions or concerns.
UIC-4-00 Firmware
Downloads
- Version
- 4.0.10.0
- Description
-
Added a feature allowing the UIC to send a status tone at the end of each transmission to indicate the absence/presence of a network connection to a host. Selection of this function requires UIC Configuration Software version 2.3.2.0 or later.
NOTE: This firmware is compatible only with MT-4E transmitter firmware version 2.10.3 or later.
- Release Date
- 25 July 2016
- Filesize
- 1.1MB
- Download
- Download software (ZIP)
Version History
- Version 4.0.10.0 25 July 2016
-
Added a feature allowing the UIC to send a status tone at the end of each transmission to indicate the absence/presence of a network connection to a host. Selection of this function requires UIC Configuration Software version 2.3.2.0 or later.
NOTE: This firmware is compatible only with MT-4E transmitter firmware version 2.10.3 or later.
- Version 4.0.9.0
-
- Added a feature allowing the UIC's Digital General Purpose Output 0 to be optionally used as a network connection status indicator. Selection of this function requires UIC Configuration Software version 2.3.1.0 or later.
- Corrected occasionally clipped audio at the end of outbound P25 transmissions.
- Version 4.0.5.0
-
- Corrected receiver muting and audio reception when operating in simplex mode.
- Version 4.0.3.0
-
- Added support the for the B side (right side) radio pair in the same subrack in which the UIC is installed. Note that B side radio support is an optional feature on the UIC.
- Added the 'Default UIC States' function to allow the UIC to go into known states upon host connect/disconnect events.
- Extended the length of the outbound audio buffer to 500ms.
- Version 3.4.1.0
-
- Updated the FSI selection programming.
- Version 3.4.0.0
-
- Added support for the Fixed Station Interface (FSI) in addition to the Codan-proprietary UIC interface, as well as new FSI-related configuration settings.
- Added the following new functions: new network-related configuration settings, simplex mode operation, automatic local repeating and outbound audio data buffering.
- Version 2.0
-
- Added a P25 Link Control Word parsing function to report the LCW of incoming P25 mode calls.
- Added the firmware flashing function to allow firmware updates in the field.
- Version 1.8
-
- Added selectable u-law/linear PCM audio encoding option.
- Added the ability to read the UIC's MAC address.
- Corrected detection of the receiver's secure/clear mode output signal.
- Some networking-related improvements.
- Version 1.6
-
- Corrected the detection of NACs when receivers are programmed with a NAC of $F7F (transparent operation where all NACs are passed through).
- Version 1.5
-
- Corrected the operation of the secure/clear transmission mode selection.
- Corrected the operation of the front panel Zeroize Keys pushbutton.
- These changes are applicable only when using the UIC with encryption-equipped radios.
- Version 1.2
-
- Corrected the audio input and output levels to reduce distortion.
- Version 1.0
-
First release.